zed-tidci-m

ZED-TIDCI-M

ZigBee S0 pulse meter

  • 2 pulse counter inputs S0 compatible
  • 2 thermal resistor inputs (NTC resistors not included)
  • Sampling and transmission rates are configurable
  • Battery powered
  • Internal antenna

btm-scarica-scheda-en
btm-richiedi-info-en

ZigBee S0 ZED-TIDCI-M pulse meter

The ZED-TIDCI-M drill is a battery supplied device and can read at the same time the temperature of 2 NTC sensors and the number of pulses launched by capacity meters (for water, gas…) connected to the 2 digital input and then regularly sending everything toward one of the 4-noks range Gateways.
Moreover, if the temperature drills are installed in an idraulic circuit as back-and-forth drills, the device can also provide the difference between them.

Technical Specs
General characteristics
Chip Ember EM250
Compatible IEEE 802.15.4
Stack EmberZnet 3.5.x (ZigBee PRO)
Modbus/RTU
Address settable through internal dip-switch
Wall-mounting with screws
Cable gland: PG9
RF characteristics Frequency: 2405 MHz ÷ 2480 MHz
Modulation: DSSS
Nominal transmission power: 2mW (3 dBm)
Receiver sensitive: -95 dBmm
Internal antenna gain: 0 dB
Outdoor/indoor range: 100m/30m
Supply High Energy Density AA 3,6V/2000mAh Lithium Battery
Battery duration: 3 years for data transmission every minute at 20°C
Input for NTC drills
NTC type drill
103AT type (R25 = 10 KOhm; Beta = 3435K)
Measurement range: -50°C ÷ +110°C
Reading resolution: 0,1°C
Reading accuracy: ±1,0°C
Measures expressed in tenths of degree
Digital input Non-isolated input for clean contact
Closure current 0,01mA. Use self cleaning contacts
Connection Plug off morsels (3,81 mm pitch)
Environment parameters Operating temperature: -10 ÷ +60°C; <80% U.R. non condensing
Storage temperature: -20 ÷ +70°C; <80% U.R. non condensing
Degree of protection: IP 55
Compliant with 2006/95/EEC, 89/336/EEC, 99/5/EEC directives
Product law applied
ETSI EN 300 328: Radio Compatibility for digital wide band transmissions
ETSI EN 301 489: Radio Compatibility
EN 61000-6-2: Electromagnetic Compatibility – Emissions
EN 61000-6-3: Electromagnetic Compatibility – Immunity
EN 60950-1: Electric security