zr-tidci-em

ZR-TIDCI-EM

Router ZigBee S0 Pulse Counter

  • 2 pulse counter inputs S0 compatible
  • 2 thermal resistor inputs (NTC resistors not included)
  • Sampling and transmission rates are configurable
  • 12-24 Vdc/Vac supply
  • Routing function
  • External antenna
  • RF power amplifier: 10 mW

btm-scarica-scheda-en
btm-richiedi-info-en

ZR-TIDCI-EM Router ZigBee S0 Pulse Counter

The ZR-TIDCI-M is supplied by electric energy and can read at the same time the temperature of 2 NTC sensors and the number of pulses launched by capacity meters (for water, gas…) connected to the 2 digital input and then regularly sending everything toward one of the 4-noks range Gateways. Moreover, if the temperature drills are installed in an idraulic circuit as back-and-forth drills, the device can also provide the difference between them.
Since the device is continuously supplied by 12-24 Vcc/Vca it can work as repeater and work as “father” device for battery supplied sensors.

Technical Specs
General characteristics
Chip Ember EM250
Compatible IEEE 802.15.4
Stack EmberZnet 3.5.x (ZigBee PRO)
Modbus/RTU
Address settable through internal dip-switch
Wall-mounting with screws
Cable gland: PG9
RF characteristics Frequency: 2405 MHz ÷ 2480 MHz
Modulation: DSSS
Nominal transmission power: 10mW (10 dBm)
Receiver sensitive: -97 dBm
Internal antenna gain: 5,5 dB
Outdoor/indoor range: 200m/50m
Supply 12-24 Vcc/Vca; 100mA; 50/60Hz
Input for NTC drills
NTC type drill
103AT type (R25 = 10 KOhm; Beta = 3435K)
Measurement range: -50°C ÷ +110°C
Reading resolution: 0,1°C
Reading accuracy: ±1,0°C
Measures expressed in tenths of degree
Digital input Non-isolated input for clean contact
Closure current 0,01mA. Use self cleaning contacts
Connection Plug off morsels (3,81 mm pitch)
Environment parameters Operating temperature: -10 ÷ +60°C; <80% U.R. non condensing
Storage temperature: -20 ÷ +70°C; <80% U.R. non condensing
Degree of protection: IP 55
Compliant with 2006/95/EEC, 89/336/EEC, 99/5/EEC directives
Product law applied
ETSI EN 300 328: Radio Compatibility for digital wide band transmissions
ETSI EN 301 489: Radio Compatibility
EN 61000-6-2: Electromagnetic Compatibility – Emissions
EN 61000-6-3: Electromagnetic Compatibility – Immunity
EN 60950-1: Electric Security